This is an automotive spraybooth exhaust fan that was installed in Texas.

Special features include: Flanged inlet and outlet; AMCA Type C spark-resistant construction; 1/4" housing and inlet box with dependent bearing pedestals; Shaft seals; V-split housing for wheel removal with horizontal split for shipping; Unitary fan and motor base; Ultra-V belt drive.

This induced draft fan for a wood-fired hot oil heater was installed in Arkansas.

Special features include: Cleanout doors on the housing and inlet boxes; Flanged inlet and outlet; Pre-spin inlet box dampers designed for 500 degrees F maximum operating temperature; Shaft seals; V-split housing for wheel removal; Cooling wheels with guards; Coupling guard.

Fans for regenerative thermal oxidizer V.O.C. abatement system. Installed in Delaware.

Special features include: Full Arrangement 8 base to suit 600 HP 1200 RPM TEFC motor; Flanged inlet and outlet; Raised cleanout door; V-split housing for wheel removal; Cooling wheel with guard; 2" PAROC insulation board with aluminized steel skin; Oil-lubricated bearings with constant-level oilers; High-temperature aluminum paint.

This is a topcoat oven combustion exhaust fan for an automotive facility installed in Delaware.

Special features include: Flanged inlet and outlet; Disjointed plug assembly with 1" air gap between the insulated plug and panel; Plug to housing sleeve; 4" PAROC insulation board with 0.0040" aluminum skin; Maximum skin temperature of 120 degrees F at 650 degrees F operating temperature; Cooling wheel with guard; Vented shaft and bearing guard.

These are fans for V.O.C abatement system, installed in Taiwan.

Special features include: Split housing; Flanged inlet and outlet; Unitary fan and motor base; 304 stainless steel wheel and shaft; Integral inlet box; Belt guard with tachometer holes; 3-coat epoxy paint finish; AMCA Type C spark-resistant construction

This model was installed in Ontario for use as an Automotive paintbooth supply fan.

Special features include: Flanged inlet and outlet; Unitary fan and motor base with 300HP motor mounted in position "Y"; Inlet boxes with dependent bearing pedestals; Quick-release cleanout doors on housing and inlet boxes; V-split housing for wheel removal, plus vertical split for shipping (discharge split section not shown).

This is a parallel fan operation with variable frequency drive for V.O.C abatement system that was installed in Texas.

Special features include: Integral inlet box; Parallel-blade outlet damper with low-leakage blade and jamb seals. Damper includes actuator and proximity switches (not shown).; Cleanout doors on housing and inlet box; Flanged inlet and outlet; V-split housing for wheel removal; AMCA Type C spark-resistant construction; 100 HP Marathon Severe duty High-efficient motors; Unitary fan and motor base with fiberglass grating and spring isolation brackets to support both fans, 600lb-load per inlet box, and customer's 2000 lb electrical panel.

This application consisted of 6 size 2450 arrangement 9 belt driven roof exhausters installed in British Columbia.

Special features include: Curb cap mounting base; Windguard; Butterfly damper; Weather hood; Extended grease leads; Access door; Variable speed v-belt drive; Sandblasted surfaces covered with hi-build epoxy.

This heavy-duty high-pressure blower is used in conjunction with a dust collector located in South Carolina.

Special features include 300 HP motor, inlet box, prespin inlet box damper c/w actuator, evase outlet, flex connectors, low maintenance bearing oilers, belt guard, shaft and bearing guard, and unitary base.